4060-xxx
Fuser exit sensor or fuser narrow media sensor removal
1.
Remove the fuser. See
2.
Cut the cable tie (A).
3.
Unplug the sensor from the fuser control board.
4.
Remove the sensor from the lower exit guide assembly.
Fuser lamp removal
1.
Remove the fuser assembly. See
2.
Disconnect the fuser lamp AC cable from the left side of the top cover assembly.
3.
Remove the two screws (A) from the left side fuser lamp contact cover.
Warning: Take care when removing the screw, as the lamp is under spring tension. When the
4-28
Service Manual
"Fuser assembly removal" on page
Narrow Media Sensor
"Fuser assembly removal" on page
contact is released, damage to the lamp or contact may occur.
4-23.
A
Exit Sensor
A(202)
4-23.