Check Device Connection Messages - Lexmark T632 Service Manual

Check device connection messages

The messages in the following table display when the printer loses communications with one of the
following devices.
User status message
Check Env Feeder
Connection
Check Tray x
Connection
Check Duplex
Connection
The messages in the following table can occur in two ways. The specified device could have been
removed from the printer, for instance to clear a paper jam. Otherwise, the device can still be
attached to the printer, but is experiencing a communications problem, not fully connected, or having
a hardware failure.
If the device is temporarily removed or not connected properly, then the user is advised to reattach it.
When the option is recognized, the printer automatically clears the error and continues. If the option
is experiencing a hardware problem, turn the printer off and back on. If the error occurs again, the
user is advised to turn the printer off, remove the option, and call for service.
User status message
Turn Printer OFF to
Enable Option
Insert Duplex Front
Cover
Close Duplex Rear Door
Explanation
Check envelope feeder connection.
Check tray x, where x=1, 2, 3, 4, or 5.
Check duplex option connection.
Explanation
A printer option, Input Tray, or Envelope Feeder, has been attached while the
printer is powered on. To use the option, the printer must first be powered off and
back on again. Data loss results if print jobs are active when the printer is power
cycled. If a print job is active, then remove the option and finish the job. The printer
automatically clears the message once the option is removed. Once the job is
complete, turn off the printer and attach the option again.
The duplex front access cover is not installed.
The duplex rear door is open.
4060-xxx
Diagnostic information
2-33