Feed To All Bins Test; Output Bin Sensor Test - Lexmark T632 Service Manual

4060-xxx

Feed to All Bins Test

This test can be used to verify that the printer can feed media to the standard bin or any installed
output options. No information will be printed on the test pages as the printhead is not turned on
during the feed test.
To run the Feed to all Bins Test:
Select Feed to all Bins Test from the menu.
•
The media feeds from the default paper source.
•
The printer feeds a separate piece of media to the standard bin first, then it feeds a separate
piece of media to each output bin installed in the following order:
Sheets fed
1
2
3
4
5
6
7
8
The test is continuous until either the Return or Stop button is pressed.

Output Bin Sensor Test

This test is used to determine whether or not the output bin sensor is working correctly for the
Standard Bin or the sensors are working for the output expander, high-capacity output stacker, 5-bin
mailbox or StapleSmart finisher, if installed.
To run the Output Bin Sensor Test for:
Standard Bin
1.
Select Output Bin Test from the menu.
2.
Select Output Bin Tests - Sensor Tests.
3.
Select Standard Bin from the menu.
The following screen is displayed:
Standard Bin
F=OP
F=Standard Bin's Bin Full Sensor
4.
Once the screen is displayed, manually actuate the sensor flag to check the Bin Full Sensor.
When the sensor is closed, CL displays, and when the sensor is open OP displays.
5.
Select Return or Stop to exit the test.
3-12
Service Manual
Output bins Sheets fed
Standard bin 9
Bin #1 10
Bin #2 11
Bin #3 12
Bin #4 13
in #5
B 14
Bin #6 15
Bin #7 16
Output bins Sheets fed
Bin #8 17
Bin #9, 18
Bin #10 19
Bin #10 20
Bin #9 21
Bin #8 22
Bin #7
Bin #6
Output bins
Bin #5
Bin #4
Bin #3
Bin #2
Bin #1
Standard bin