Communications Board Removal - Lexmark T632 Service Manual

4060-xxx

Communications board removal

1.
Remove the outer shield. See
2.
Remove features and options from the interconnect board only if they block access.
Warning: Observe all ESD precautions while handling ESD-sensitive parts. See
3.
Remove the communications board mounting screw (A).
B(201)
4.
Remove the communications board shield mounting screw (B).
5.
The communications board is held in place by a ground clip (C) on the shield that attaches the
communications board shield to the side frame. Pull the board up to unclip the shield.
6.
Remove the screws that hold the shield to the communications board.
Note: Retain the shield and screws to install on the new board.
4-18
Service Manual
"Outer shield removal" on page
ESD-sensitive parts" on page
C
4-1.
A(232)
4-52.
"Handling