Lexmark T632 Service Manual page 199

4.
Remove the power takeoff shaft and spring (A) through the bottom of the printer.
5.
Remove all cables from the cable clamps (B) on the main drive assembly.
6.
Remove the ground cable screw (C).
7.
Remove the main drive assembly mounting screws (D).
8.
Remove the link from the rear of the main drive assembly.
9.
Disconnect the cable from the main drive motor.
10.
Remove the main drive assembly.
Note: Be sure the main drive assembly gear shaft aligns with the hub on the left side frame when
reinstalling the main drive assembly.
Warning: Whenever the main drive assembly is removed from the printer it must be handled very
carefully. Do not allow any of the gears to come in contact with any metal or other hard
surface to avoid gear damage. It is also very important not to let any dirt, paper, staples,
or other material come in contact with the grease in the gears.
4060-xxx
4-45
Repair information