Operator Panel Cable Removal - Lexmark T632 Service Manual

4060-xxx

Operator panel cable removal

Note: Pay careful attention to the cable routing through the printer before you remove the operator
panel cable.
1.
Remove the left cover. See
2.
Remove the upper front cover. See
3.
Remove the outer system board shield. See
4.
Disconnect the operator panel cable from connector J15 on the system board.
5.
Remove the operator panel. See
6.
Remove the cable retainer from the left side of the upper front cover hinge assembly.
Note the routing of the operator panel and cover closed switch cables.
7.
Remove the old cable from the printer.
8.
Plug the new operator panel cable into the operator panel.
9.
Snap the operator panel into the upper front cover.
4-50
Service Manual
"Left door removal" on page
"Upper front cover removal" on page
"Outer shield removal" on page
"Operator panel assembly removal" on page
4-9.
4-12.
4-52.
4-48.