Lexmark T632 Service Manual page 57

User attendance messages (continued)
Primary message
Install Tray x
or Cancel Job
Load Staples
Priming Failed
Retry. Go/Stop?
Secondary message Explanation
Tray x=Tray 2, Tray 3, Tray 4, Tray 5.
This message is displayed when a paper handling
option has been hot unplugged. The printer requires
the reinstallation of the option to print a page which
has been formatted by the interpreter before the option
was removed.
The following actions may be taken:
• Install the option.
• Press Menu until Busy/Waiting displays. Select
one of the following:
- Cancel Job
- Reset Printer
- Reset Active Bin
If the message cannot be cleared, go to
service check" on page 2-64.
This message displays when the Staples Empty Alarm
is activated and one of the following occurs:
• There are no staples in the stapler.
• The maximum number of staples have been fired
after the engine has reported that the staple
cartridge is low.
• The printer does not detect the staple cartridge is
present.
The following actions may be taken:
• Install a new staple cartridge to clear this message
and select Start or Continue to resume printing
the staple job.
• Choose to ignore the Load Staples message for
this print job by pressing Go or Select. The printer
starts or resumes printing, but does not staple the
rest of the job.
• Press Menu until Busy/Waiting displays. The
following actions may be available:
- Cancel Job
- Reset Printer
- Reset Active Bin
This message displays when an error has occurred
during the staple priming operation. This message not
only notifies the user that a specific error interfered
with the priming, but allows the user to request the
process begin again.
The following actions are available:
• Press Go to restart the priming operation.
• Press Return or Stop to cancel the priming
operation.
Diagnostic information
4060-xxx
"Input tray(s)
2-23