Lexmark T632 Service Manual page 60

4060-xxx
User attendance messages (continued)
Primary message
37 Insufficient Memory
38 Memory Full
39 Complex Page
50 PPDS Font Error
51 Defective Flash
52 Flash Full
2-26
Service Manual
Secondary message
Held Jobs may be lost
Explanation
This message displays when the printer memory used
to restore the Print and Hold jobs from the disk and
found that some or all of the jobs could not be restored.
The printer ran out of memory while attempting to
restore the jobs.
• Press Go to clear the message. Some of the Print
and Hold jobs on the disk will not be restored. They
remain on the disk, but cannot be accessed.
• Press Menu until Busy/Waiting appears. The
following functions may be available:
- Cancel Job
- Reset Printer
- Reset Active Bin
This message displays when the printer is processing
an incoming job and there is insufficient memory
available to continue processing the job. The following
actions may be taken:
• Press Go to clear the message. Perform the
defragment operation:
- Perform the defragment operation
- Delete fonts, macros, and other data in RAM
- Install additional memory
• Press Menu to display Busy/Waiting. The following
functions may be available:
- Cancel Job
- Reset Printer
- Reset Active Bin
This message displays when the page is too complex
to print. The following actions may be taken:
• Press Go to clear the message and continue the
job. Some data loss may occur. Simplify the print
job and reprint, if necessary.
• Press Menu until Busy/Waiting appears. The
following selections are possible:
- Cancel Job
- Reset Printer
- Reset Active Bin
This message displays when the PPDS interpreter has
encountered a font error.
Note: This error may only occur when the printer is
formatting PPDS print data.
The following actions may be taken:
• Press Go to clear the message and continue
processing the job.
• Press Menu until Busy/Waiting appears. The
following are available:
- Cancel Job
- Reset Printer
- Reset Active Bin
This message displays when the printer detects a
defective flash. This error may occur at power on, or
during flash format and write operations. Press Go to
clear the message. The flash is marked as bad and
normal operation continues. Flash operations are not
allowed until the problem is resolved.
This message displays when there is not enough free
space in the flash memory to hold the resources that
have been requested to be written to flash.