Screw Identification Table - Lexmark T632 Service Manual

4060-xxx

Screw identification table

The following table contains screw types, locations, and quantities necessary to service the printer.
Each screw callout in the removal procedure graphic displays the screw reference number listed in
the table. Pay careful attention to each screw type location when doing removals. You must install the
correct screw type in each location during reassembly.
Reference
Screw type
number
M3.5x8 mm Thread
Cutting
M3.5x12 mm
Thread Cutting
M3x5 mm Taptite
4-6
Service Manual
Location
right side frame to center pan
toner level sensor
charge roll bracket
main drive gearbox
EP module to left and right side frame
developer drive assembly
stacker duct to frame
cartridge hold down assembly
MPT deflector
laser cover
deflector
spring
system board
integrated tray (ITC) board
stacker support to right side frame
paper alignment assembly
toner cartridge guide track
left side frame to center pan
right side frame to center pan
deflector
INA cover
(2 screws per cover)
Purpose Qty
attach 1
mounting 1
mounting 1
mounting 3
attach 9
mounting 2
mounting 2
mounting 2
mounting 2
mounting 4
mounting 2
mounting 1
mounting 2
(front)
mounting 1
attach 2
mounting 2
mounting 2
attach 3
attach 2
mounting 2
attach 6