Upper Front Cover Hinge Assembly Removal - Lexmark T632 Service Manual

4060-xxx

Upper front cover hinge assembly removal

1.
Remove the upper front cover. See
2.
Remove the laser cover assembly. See
3.
Remove the C-clips (A) from the upper front cover hinge assembly left and right hinge pins and
remove the pins. Note the pin orientation and the C-clip location on the inside of each hinge.
4.
Detach the two springs (B) from the upper front cover hinges.
5.
Detach spring (C) from the left side of the hinge assembly.
6.
Remove the cover closed switch assembly.
C
7.
Disconnect the operator panel cable from the operator panel assembly.
8.
Raise the upper front cover hinge assembly to a position that lets you lift the left pivot arm from
the mounting bracket (D).
9.
Lift the left pivot arm from the bracket and move the upper cover hinge assembly toward the left
to clear the right upper cover pivot arm from the mounting bracket.
10.
Remove the upper front cover hinge assembly.
4-62
Service Manual
"Upper front cover removal" on page
"Laser cover removal" on page
A
D B
B A
A
4-12.
4-14.
B