Main Drive Service Check - Lexmark T632 Service Manual

4060-xxx

Main drive service check

Service tip: Excessive gear or main drive assembly noise is usually caused by a defective motor
assembly or system board.
Service tip: If there are equally spaced horizontal lines across the page, go to
evenly spaced horizontal lines or marks" on page
Warning: Whenever the gearbox assembly is removed from the machine it must be handled very
carefully. Do not allow any of the gears to come in contact with any metal or other hard
surface to avoid gear damage. It is also very important not to let any dirt, paper, staples,
or other material come intact with the grease in the gearbox assembly.
FRU
1 Main drive assembly
(excessive noise or
vibration)
2 Main drive motor assembly
(excessive noise, gears
ratcheting and so on)
3 Main drive motor cable
4 Motor does not turn, no
gear error code 936 or user
message 201 Paper Jam
displays.
2-68
Service Manual
2-80.
Action
Remove the controller board and run a Diagnostic Print Test in the
continuous mode. Check the main drive assembly for any excessive
noise or vibration. Determine if the noise is in the main drive, toner
cartridge, fuser, or main drive gearbox. Look for any loose or worn
parts in the developer drive assembly, main drive gearbox, or fuser.
Repair as necessary.
A service error code 936 - Transport Motor may be displayed. Check
the voltage at J24-6 on the system board. It measures approximately
+5 V dc when the motor is not running and goes to 0 V dc when the
motor is running. If incorrect, replace the system board. If this does
not fix the problem, replace the main drive motor.
Check the continuity of the main drive motor cable. If incorrect,
replace the cable.
Check the voltages at J24 on the system board.
Pin Voltage
Static When main drive
motor is running
J24-11 +24 V dc
J24-8 +5 V dc 0 V dc
J24-7 +5 V dc 0 V dc
J24-6 +5 V dc +2.5 V dc
J24-5 +5 V dc 0 V dc
J24-4 +5 V dc +5 V dc
J24-1 +5 V dc 0 V dc
If the voltage is incorrect, replace the FRUs in the following order:
• Main drive motor assembly
• System board
"Print quality—