Memory; Sodimms; Ddr3-Sdram Sodimms - HP 200 G1 ST Maintenance And Service Manual

Table of Contents

Advertisement

Memory

The computer comes with double data rate 4 synchronous dynamic random access memory (DDR3-SDRAM)
dual inline memory modules (DIMMs).

SODIMMs

The memory sockets on the system board can be populated with up to two industry-standard SODIMMs.
These memory sockets are populated with at least one preinstalled SODIMM. To achieve the maximum
memory support, you can populate the system board with up to 8 GB of memory.

DDR3-SDRAM SODIMMs

For proper system operation, the SODIMMs must be:
industry-standard 204-pin
unbuffered non-ECC PC3-12800 DDR3-1600 MHz-compliant
1.5 volt DDR3-SDRAM SODIMMs or 1.35 volt DDR3L-SDRAM SODIMMs
The DDR3-SDRAM SODIMMs must also:
support CAS latency 11 DDR3 1600 MHz (11-11-11 timing)
contain the mandatory Joint Electronic Device Engineering Council (JEDEC) specification
In addition, the computer supports:
512-Mbit, 1-Gbit, and 2-Gbit non-ECC memory technologies
single-sided and double-sided SODIMMS
SODIMMs constructed with x8 and x16 devices; SODIMMs constructed with x4 SDRAM are not supported
NOTE:
The system will not operate properly if you install unsupported SODIMMs.
Memory
17

Advertisement

Table of Contents
loading

Table of Contents