Diskette Drive (Optional) - HP xw4400 Service And Technical Reference Manual

4. Connect the power, drive, and audio (if required) cables to the drive and system board. On Linux
systems, connect the audio cable to the AUX-IN connector.
NOTE
Figure 4-39

Diskette drive (optional)

To remove a diskette drive:
1. Disconnect power from the system
access panel
2. Disconnect the data 1 and power 2 cables from the back of the diskette drive.
Figure 4-40
90 Chapter 4 Removal and replacement procedures
The audio cable is only required for Linux-based systems.
Connecting the optical drive cable to the system board
(Predisassembly procedures on page
(Side access panel on page
Disconnecting the cables from the diskette drive
66), and the front bezel
60), remove the side
(Front Bezel on page 67).
ENWW