Replacing The Cover And Front Bezel - HP x4000 Technical Reference Manual

Installing or Replacing Parts and Accessories
Cover and Front Bezel

Replacing the Cover and Front Bezel

To replace the cover and front bezel:
1. Ensure that all internal cables are properly connected and safely
routed.
2. If necessary, replace the front bezel:
a. Align the plastic quarter rounds on the inside of the bezel with the
sheet metal sockets on the right side of the chassis.
b. Rotate the bezel into position and verify that the plastic tabs on
the left side of the bezel click into position on the Workstation
chassis.
The bezel should be flush against the Workstation.
3. Standing at the back of the Workstation, lower the cover onto the
chassis (aligning the guide rail on the bottom inside edge of the cover
with the bottom edge of the Workstation chassis).
4. Shut the cover ensuring that the guides on the top of the cover slide
into the rails at the top of the chassis.
5. Slide the cover forward, then tighten the two thumbscrews.
6. If required, lock the cover using the key provided.
148
This manual downloaded from http://www.manualowl.com
Chapter 10