Replacing A Processor; Speaker Removal - IBM NetVista Hardware Maintenance Manual
Hardware maintenence manual for netvista 6838 and 6848 systems
Hide thumbs
Also See for NetVista:
- Hardware maintenance manual (211 pages) ,
- Hardware manual (135 pages) ,
- Guide utilisateur (124 pages)
Table of Contents
Advertisement
2. Remove the board from the chassis.
3. Remove the processor from the old system board and install it on the new
system board.
4. Remove any of the following installed options on the old system board, and
install them on the new system board.
v Memory modules
5. Ensure that the new system board jumper settings match the old system board
jumper settings.
Replacing a processor
Make sure the processor is fully seated in its socket and that the goal post latches
are engaged.
Important:
1.
Make sure the fansink and air baffle (if any) are installed to prevent processor
overheating.
2.
If the processor is not installed correctly, the system board and the processor can be
damaged.
Speaker removal
1. Remove the cover (see "Removing the cover" on page 26).
Chapter 6. FRU information (service only)
43
Advertisement
Table of Contents
