IBM NetVista Hardware Maintenance Manual page 29

– Specify the capacity and physical size of diskette drive A
– Enable or disable write-protect for the diskette drive
v Event Log Configuration: Select this choice to:
– Check if there is space available in the event log
– Check if the event log contents are valid
– View the event log
– Clear the event log after rebooting
– Enable logging of events
– Enable logging of ECC events
– Mark all events as having been read
v Video Configuration: Select this menu to:
– Set the aperture size for the AGP video controller
– Select the primary video adapter to be used during boot
Security: Select this menu to:
v View if there is a Supervisor or User password set
v Set a Supervisor or User password
v Clear the User password
v Set BIOS Setup Utility access rights for user level
v Enable the system to boot without a password
Power: Select this menu to:
v Enable or disable the BIOS power management feature
v Specify the amount of time before the computer enters standby mode
v Enable power management for hard disks during standby modes
v Specify the ACPI suspend state
Boot: Select this menu to:
v Choose between POST messages or OEM graphic on boot
v Enable the computer to boot without running certain POST tests
v Enable the BOIS to scan the flash memory for user binary files
v Specify the mode of operation if an AC power loss occurs
v Specify how the computer responds to an incoming call on an installed modem
when the power is off (APM mode only)
v Specify how the computer responds to a LAN wake up event (APM mode only)
v Specify how the computer responds to a PCI power management event (APM
mode only)
v Determine the action of the system when a LAN wake up event occurs (ACPI
mode only)
v Specify the boot sequence according to device type
v Specify which IDE hard disk to boot from
Exit: Select this menu to:
v Exit and save changes in CMOS RAM
v Exit without saving any changes made in the BIOS Setup program
v Load factory defaults for all Setup options
v Load custom defaults for Setup options
21
Chapter 4. Configuration