IBM NetVista Hardware Maintenance Manual page 64

56
IBM NetVista Type 6838, 6848: Hardware Maintenance Manual
Diagnostic Error Code
011-198-XXX Serial port test aborted
011-199-XXX Serial port test failed, cause
unknown
011-2XX-XXX Serial port signal failure
014-000-XXX Parallel port Interface Test
Passed
014-001-XXX Parallel port Presence
014-002-XXX 014-003-XXX Parallel port
Timeout/Parity error
014-013-XXX 014-014-XXX Parallel port
Control Signal/Loopback test failure
014-015-XXX Parallel port External Loopback
failure
014-027-XXX Parallel port
Configuration/Setup error
014-03X-XXX 014-04X-XXX Parallel port
failure
014-195-XXX Parallel port Test aborted by
user
014-196-XXX Parallel port test halt, error
threshold exceeded
014-197-XXX Parallel port test warning
014-198-XXX Parallel port test aborted
FRU/Action
1. If a component is called out, make sure
it is connected and/or enabled
2. Flash the system and re-test
3. Go to the "Undetermined problems"
section
1. Go to the "Undetermined problems"
section
2. Flash the system and re-test
3. Replace component under function test
1. External serial device
2. System board
1. No action
1. Remove external parallel device, if
present
2. Run setup, enable port
3. System board
1. System board
1. System board
1. Wrap plug
2. System board
1. Run Setup, enable port
2. Flash the system
3. System board
1. System board
1. Information
2. Re-start the test, if necessary
1. Press F3 to review the log file
2. Re-start the test to reset the log file
1. Make sure the component that is called
out is connected and/or enabled
2. Re-run test
3. Component that is called out in warning
statement
4. Component under test
1. If a component is called out, make sure
it is connected and/or enabled
2. Flash the system and re-test
3. Go to the "Undetermined problems"
section