IBM NetVista Hardware Maintenance Manual page 68

60
IBM NetVista Type 6838, 6848: Hardware Maintenance Manual
Diagnostic Error Code
025-198-XXX IDE interface test aborted
025-199-XXX IDE interface test failed, cause
unknown
030-000-XXX SCSI interface Test Passed
030-00X-XXX 030-01X-XXX SCSI interface
failure
030-027-XXX SCSI interface
Configuration/Setup error
030-03X-XXX 030-04X-XXX SCSI interface
error
030-195-XXX SCSI interface Test aborted by
user
030-196-XXX SCSI interface test halt, error
threshold exceeded
030-197-XXX SCSI interface test warning
030-198-XXX SCSI interface test aborted
030-199-XXX SCSI interface test failed, cause
unknown
FRU/Action
1. If a component is called out, make sure
it is connected and/or enabled
2. Flash the system and re-test
3. Go to the "Undetermined problems"
section
1. Go to the "Undetermined problems"
section
2. Flash the system and re-test
3. Replace component under function test
1. No action
1. SCSI signal cable
2. Check power supply
3. SCSI device
4. SCSI adapter card, if installed
5. System board
1. SCSI signal cable
2. Flash the system
3. SCSI device
4. SCSI adapter card, if installed
5. System board
1. SCSI signal cable
2. Check power supply
3. SCSI device
4. SCSI adapter card, if installed
5. installed System board
1. Information
2. Re-start the test, if necessary
1. Press F3 to review the log file
2. Re-start the test to reset the log file
1. Make sure the component that is called
out is connected and/or enabled
2. Re-run test
3. Component that is called out in warning
statement
4. Component under test
1. If a component is called out, make sure
it is connected and/or enabled
2. Flash the system and re-test
3. Go to the "Undetermined problems"
section
1. Go to the "Undetermined problems"
section
2. Flash the system and re-test
3. Replace component under function test