Chapter 4. Configuration; Using The Configuration/Setup Utility Program; Starting The Configuration/Setup Utility Program; Choices Available From The Configuration/Setup Utility Main Menu - IBM NetVista Hardware Maintenance Manual

Chapter 4. Configuration

Using the Configuration/Setup Utility program .

Starting the Configuration/Setup Utility program 19

Choices available from the Configuration/Setup
Utility main menu .
The following configuration programs are provided with your computer:
v Configuration/Setup Utility program
v SCSISelect Utility program (some models)
Using the Configuration/Setup Utility program
This section provides the instructions for starting the Configuration/Setup Utility
program and descriptions of the menu choices that are available.
Starting the Configuration/Setup Utility program
Complete the following steps to start the Configuration/Setup Utility program:
1. Turn on the computer and watch the monitor screen.
2. When the message, Press F1 for Configuration/Setup, appears, press F1.
3. Follow the instructions that appear on the screen.
Choices available from the Configuration/Setup Utility main
menu
From the Configuration/Setup Utility main menu, you can select settings that you
want to change.
Note: The choices on some menus might differ slightly from the ones that are
Descriptions of the choices available from the main menu are as follows:
Maintenance: Select this choice to:
v Display processor speed
v Clear all passwords
v Clear BIS Credentials
v View the Extended Configuration menu
v Display CPU information
v Display the CPU Stepping Signature
v Display the CPU Microcode Update Revision
Main: Select this menu to:
© Copyright IBM Corp. 2000
. . . . . . . . .
This program is part of the BIOS code that comes with your computer. You can
use this program to configure serial- and parallel-connector assignments, change
the drive startup sequence, set the date and time, and set passwords. See "Using
the Configuration/Setup Utility program" on page 19 for more information.
With the built-in SCSISelect Utility program, you can configure the devices that
are attached to the optional SCSI adapter. See "Using the SCSISelect Utility
program (some models)" on page 22 for more information.
described in this book, depending on the BIOS version in your computer.
. 19 Using passwords
Using the SCSISelect Utility program (some models) 22
Starting the SCSISelect Utility program .
. 19 Choices available from the SCSISelect menu
. . . . . . . . .
.
. . 22
. . 22
. . 22
19