Recovering Or Installing Device Drivers - IBM NetVista Hardware Maintenance Manual

4. Locate jumper J8C2/config. (recovery jumper) on the system board.
5. Remove the jumper to enable BIOS recovery mode.
6. Reinstall the computer cover, see "Replacing the cover" on page 38.
7. Reconnect all external cables and power cords and turn on the attached
devices.
8. Insert the BIOS flash diskette in the diskette drive.
9. Restart the computer. The BIOS begins the power-on self-test.
10. There will be 2 beeps, followed by diskette action, followed by 2 more beeps.
When this is finished, remove the BIOS flash diskette from the diskette drive.
11. Remove any media (diskettes, CDs, or tapes) from the drives, shut down your
operating system.
12. Turn off the computer and all attached devices and disconnect all external
cables and power cords.
13. Remove the cover. See "Removing the cover" on page 26.
14. Replace the J8C2 jumper to the normal position (pins 1 and 2) to return to
normal startup mode.
15. Reinstall the computer cover, see "Replacing the cover" on page 38.
16. Reconnect the external cables and power cords; then turn on the attached
devices and the computer, which should start up normally.

Recovering or installing device drivers

Use the following steps to recover or install device drivers on your computer.
3 2 1
Recovery jumper
15
Chapter 3. Diagnostics