IBM NetVista Hardware Maintenance Manual page 67

Diagnostic Error Code
020-197-XXX PCI test warning
020-198-XXX PCI test aborted
020-199-XXX PCI test failed, cause unknown 1. Go to the "Undetermined problems"
020-262-XXX PCI system error
025-000-XXX IDE interface Test Passed
025-00X-XXX 025-01X-XXX IDE interface
failure
025-027-XXX IDE interface
Configuration/Setup error
025-02X-XXX 025-03X-XXX 025-04X-XXX IDE
Interface failure
025-195-XXX IDE interface Test aborted by
user
025-196-XXX IDE interface test halt, error
threshold exceeded
025-197-XXX IDE interface test warning
FRU/Action
1. Make sure the component that is called
out is connected and/or enabled
2. Re-run test
3. Component that is called out in warning
statement
4. Component under test
1. If a component is called out, make sure
it is connected and/or enabled
2. Flash the system and re-test
3. Go to the "Undetermined problems"
section
section
2. Flash the system and re-test
3. Replace component under function test
1. PCI card
2. Riser card, if installed
3. System board
1. No action
1. IDE signal cable
2. Check power supply
3. IDE device
4. System board
1. IDE signal cable
2. Flash the system
3. IDE device
4. System board
1. IDE signal cable
2. Check power supply
3. IDE device
4. System board
1. Information
2. Re-start the test, if necessary
1. Press F3 to review the log file
2. Re-start the test to reset the log file
1. Make sure the component that is called
out is connected and/or enabled
2. Re-run test
3. Component that is called out in warning
statement
4. Component under test
Chapter 7. Symptom-to-FRU index
59