IBM NetVista Hardware Maintenance Manual page 28

v Display BIOS version
v Display processor type
v Display processor speed
v Display the system bus frequency
v Display second-level cache size and whether it is ECC-capable
v Display the total amount of RAM
v Display the amount and type of RAM in the memory banks
v Set the default language
v Toggle error reporting if ECC is supported
v Set the system date and time
Advanced: Select this menu for the following tasks:
v Extended Configuration: If Used is displayed, User-defined has been selected in
v Boot Configuration: Select this choice to:
v Peripheral Configuration: Select this choice to:
v IDE Configuration:
v Diskette Configuration: Select this choice to:
20
IBM NetVista Type 6838, 6848: Hardware Maintenance Manual
Extended Configuration under the Maintenance Menu.
– Specify if manual configuration is desired for Plug and Play devices
– Clear the PCI/Plug and Play configuration data stored in flash memory on
next boot
– Specify the power-on state of the Numlock feature
– Configure serial port A
– Specify the base I/O address for Serial Port A, if Serial Port A is Enabled.
– Specify the interrupt for Serial Port A, if Serial Port A is Enabled.
– Configure the parallel port.
– Select the mode for the parallel port. Not available if the parallel port is
disabled.
– Specify the base I/O address for the parallel port.
– Specify the interrupt for the parallel port.
– Specify the DMA Channel (only available when parallel port Mode is set to
ECP).
– Enable or disable the onboard audio subsystem.
– Enable or disable the LAN device.
– Enable or disable USB legacy support.
– IDE Controller: Choose Disabled, Primary, Secondary, or Both.
– Hard disk pre-delay: Enable to insert a delay before detecting IDE drives in
the system.
– Primary IDE master: Select to review configuration and choose device
detection.
– Primary IDE slave: Select to review configuration and choose device
detection.
– Secondary IDE master: Select to review configuration and choose device
detection.
– Secondary IDE slave: Select to review configuration and choose device
detection.
– Enable or disable the integrated diskette controller