Restore Default Command; Shutdown Command - Watchguard V10 Command Line Interface Manual

CHAPTER 2: Administration Mode Commands
Arguments

restore default command

WG#admin<ENTER>
WG(admin)#restore_default
Effect
Arguments
Results

shutdown command

WG#admin<ENTER>
WG(admin)#shutdown
Effect
38
automatically logged out of the appliance, but after
a few minutes (and a considerable display of status
messages), the main login prompt will appear. You
can log in again at this time.
None.
Reinitializes this appliance and restores the
original "factory default" configuration. Once this
process is complete, you can log in again, then start
over with appliance installation, configuration and
policy creation, either by manual entry or
importing of a profile from another appliance.
None.
After applying this command, the CLI will
immediately record a series of "restoring" status
messages, along with "please wait..." messages.
When the restoration is complete, the main login
prompt will appear.
You can now log into the appliance with the user
name of "admin" and the password of "admin" to
begin reconfiguration of this appliance.
WatchGuard Vclass 5.1