History Command; Second Level Configuration Mode Commands - Watchguard V10 Command Line Interface Manual

CHAPTER 3: Configuration Mode Commands

history command

WG#config<ENTER>
WG(config)#history
Effect
Arguments
Example
Results
Executed Commands:
0 ike
1 address
2 address "pubs" -host 10.10.99.1
3 show address pubs
4 dos
5 denial
WG(config)#

Second level configuration mode commands

The following sections detail the second-level configura-
tion commands, has been divided into "task" or "topical"
collections, which include the following:
• "Level 2 certificate configuration commands" on
page 67
66
Shows the last 20 commands exercised at this level
of CLI. Note, too, that you can apply it at any level
of the CLI.
For example, you may apply the "history"
command after extensive policy creation, and see a
series of 20 commands, starting with "64" and
ending with "83"–the most recent command
being listed as 83.
None
WG(config)#history<ENTER>
WatchGuard Vclass 5.1