Watchguard V10 Command Line Interface Manual page 99

Example
private command (configure interface level, V10
only)
WG#config<ENTER>
WG(config)#interface<ENTER>
WG(config-if)#private <a.b.c.d> </
prefix|mask>
[no] dhcp_server -clients NUMBER [-
lease_time NUMBER]
Effect
WatchGuard Command Line Interface Guide
Second level configuration mode commands
Put "no" in front of this command to turn off the
DHCP server on this interface.
[dhcp_relay <a.b.c.d>]
This allows you to use a separate DHCP server on
your network to serve DHCP addresses, with the
Vclass acting as a DHCP agent.
WG(config-if)#interface 0 10.12.12.7
255.255.255.0 \
-mtu 1500 -100_half_duplex no
dhcp_server<ENTER>
or
WG(config-if)#interface 0 10.12.12.7/24 -mtu
1500 \
-100_half_duplex no dhcp_server<ENTER>
or
WG(config-if)#interface 0 10.12.12.7/24 -mtu
1500 \
-100_half_duplex dhcp_relay
10.0.0.253<ENTER>
Use this command to configure DHCP server
options assigned to a WatchGuard V10 appliance's
Private (0) interface.
85