Level 2 Remote Access Service (Ras) Configuration Commands - Watchguard V10 Command Line Interface Manual

CHAPTER 3: Configuration Mode Commands
Level 2 Remote Access Service (RAS)
configuration commands
group_profile command (configure RAS level)
WG#config<ENTER>
WG(config)#ras<ENTER>
WG(config-ras)#group_profile <"name"> \
[no][-address_pool <"address_group">] \
[-dns <a.b.c.d>] [-session_time_out
<number> <min|hr>] \
[-idle_time_out <number> <min|hr>] \
[-concurrent_logins_per_user <number>]
Effect
Arguments
102
Creates a new RAS group profile (or modifies an
existing profile) that controls the connection
parameters of all associated remote access user
accounts.
<"name">
This argument records a name for this group
profile, which will be used when creating
individual user profile accounts.
[no] [-address_pool <"address_group">]
This argument specifies the name of an address
group containing a pool of internal IP addresses
assigned to remote access connections.
[-dns <a.b.c.d>]
This argument assigns a DNS IP address to the
remote users belong to this group.
[-session_time_out <number> <min|hr>]
This argument limits the total time any one account
user can continuously log into the network. The
default time limit is 8 (hours).
[-idle_time_out <number> <min|hr>]
This argument sets the time limit for an inactive
WatchGuard Vclass 5.1