Logging Out Of The Appliance - Watchguard V10 Command Line Interface Manual

CHAPTER 1: Using the Command Line Interface
usage syntax. For example, here is a help command
that requests (and obtains) the command argument
options and syntax used to configure a security policy:
WG#configure
WG(config)#policy?
policy <"name"> [<source> <destination> <interface
num>]
[bi_directional]> <"n]
left.
|
fragmentation_required]
time_exceeded]
network_unreachable]
host_unreachable]
port_unreachable]

Logging out of the appliance

After you have completed your setup or administration
tasks, you can log out of the appliance by following these
steps:
1 At the current prompt (at any level of the CLI), type
top and press <ENTER>.
2
When the WG# prompt is displayed, type exit and press
<ENTER>.
You are logged out of the appliance. You can disconnect the
terminal session, and physically disconnect your workstation
from the appliance if necessary.
18
[-position <num>]
[-firewall <pass|block|authenticate|reject>]
[<-service|-vlan|-nat|-qos|-schedule|-ipsec [no]
[<-tosF|-tosR> <bbbbbb>] # b is <0|1>;msb from
[-log_per_policy [enable|disable] ]
[-icmp_error_handling_per_policy [[global | all]
]
[[no]
[[no]
[[no]
[[no]
[[no]
]
WatchGuard Vclass 5.1