Watchguard V10 Command Line Interface Manual page 134

CHAPTER 3: Configuration Mode Commands
Arguments
Example
user_domain (configure tenant level)
WG#config<ENTER>
WG(config)#tenant<ENTER>
WG(config-tenant)#user_domain <"name"> <-id num>
radius_port port]
backup_radius_port port]
120
<"name">
This argument records the name assigned to this
VLAN tenant (for use in security policies.)
<-id num>
This argument record the VLAN ID as "id"
followed by the number (between 1 and 4096)
assigned to this tenant.
<-interface [0 | 2| 3]>
This argument specifies which interface (0, 2, or 3)
this VLAN tenant is associated with.
[-ip a.b.c.d/e]
This argument records the IP address and subnet
assigned to the 0 (private) or 2 (DBZ) interface, if
one of those are specified.
[-gateway a.b.c.d]
This argument notes the gateway IP address for
this tenant, if needed.
-public <default|<a.b.c.d/e>
This allows you to specify a public VLAN IP
address and gateway.
WG(config-tenant)#vlan <"execs"> -interface 1
192.168.12.34 \
-id 366 <ENTER>
[-public <default|<a.b.c.d/e>>
<-idle_time_out m> <-radius_ip a.b.c.d>[-
<-radius_secret 'secret'>
[-backup_radius_ip a.b.c.d][-
[-backup_radius_secret 'secret']
<-radius_timeout sec> <-radius_retry n>
[-use_login_id_with_domain_name <on|off>]
WatchGuard Vclass 5.1