Watchguard V10 Command Line Interface Manual page 137

Effect
Arguments
Example
Configure dynamic routing
WG#config<ENTER>
WG(config)#system<ENTER>
WG(config-sys)#route<ENTER>
WG(config-route)# [no] dynamic
[import|restart]
Effect
WatchGuard Command Line Interface Guide
Level 3 configuration mode commands
Configures a new static route utilized by traffic
passing through this WatchGuard appliance.
<destination>
Use this argument to record the IP address of the
destination subnet.
</prefix|mask>
Use this argument to record the number of bits in
the subnet mask, or the destination subnet mask.
<gateway>
Use this argument to record the IP address of the
next gateway to the destination subnet.
interface <0|1|2>
This argument specifies which interface in this
security appliance is used for outgoing traffic using
this route.
delete
Type this argument before typing the arguments
for a route, to deactivate that particular route.
WG(config-route)#static 0.0.0.0/0 \
105.10.74.122 pub<ENTER>
Configures dynamic routing in this WatchGuard
Firebox Vclass security appliance.
123