Level 2 Quality Of Service (Qos) Configuration Commands - Watchguard V10 Command Line Interface Manual

CHAPTER 3: Configuration Mode Commands
Examples
Level 2 Quality of Service (QoS)
configuration commands
action command (configure Quality of Service level)
WG#config<ENTER>
WG(config)#qos <ENTER>
WG(config-qos)#action <"name"> -
bandwidth_weight \
<1-100>
Effect
Arguments
100
WG(config-ipsec)#proposal "new_prop1" -
antireplay \
32 -esp {3des md5 10hrs} {des md5 5hr
10MB -ah \
{sha 34min 100MB}<ENTER>
# This example shows the creation of a
new proposal.
WG(config-ipsec)# prop my_proposal + -ah
\
{ sha 8hr }
# This example shows the addition of a new AH
transform to an existing proposal.
Records a new QoS action or modifies an existing
action.
<"name">
This argument, immediately following the
command, notes the name assigned to this new
QoS action.
-bandwidth_weight <"1-100">
This argument (and the required value) determine
the level of QoS based on the WFQ algorithm.
WatchGuard Vclass 5.1