To Assign Network Addresses To Appliance Interfaces; To Complete System Configuration - Watchguard V10 Command Line Interface Manual

CHAPTER 1: Using the Command Line Interface
To assign network addresses to appliance
interfaces
To assign network addresses to the data interfaces, use
these commands (along with the arguments and values
noted later in this user guide):
Command
WG(config-if)#interface 0
WG(config-if)#interface 1
WG(config-if)#interface 2
WG(config-if)#ha2

To complete system configuration

To complete the initial system configuration, use these
commands:
Command
WG(admin)#passwd
WG(config-sys)#route
WG(config-sys)#dns
WG(config-sys)#snmp
WG(config-sys)#log
WG(config-sys)#ldap
WG(config)#tunnel_switch
20
Additional Information
if a DMZ interface is present
if an HA2 port is present
Description
change the default password to a new,
secure password
includes both static and dynamic
routes
connect to a domain name server
connect to any SNMP management
stations
activate needed system activity
logging
connect this appliance to an LDAP
server
activate WatchGuard tunnelswitching
features
WatchGuard Vclass 5.1