Conn_Idle_Timeout Command; Ha_Instant_Sync Command - Watchguard V10 Command Line Interface Manual

CHAPTER 4: Debug Mode Commands
Arguments
Example

conn_idle_timeout command

WG#debug<ENTER>
WG#debug conn_idle_timeout [show | set <idle timeout> |
set_default | -h | -? ], where
show
set <idle timeout> Set the connection idle timeout (in
seconds, 1-86400)
Effect
Example

ha_instant_sync command

WG#debug<ENTER>
WG#debug ha_instant_sync [show | enable | disable |
set_default | -h | -? ], where
show
enable
disable
130
enable
Enables HTTP debugging.
disable
Disables HTTP debugging.
logon_html [standard | alternate ]
Standard allows you to use the deault HTML logon
debugging page. Alternate allows you to use the
alternate HTML logon page.
WG#debug<ENTER>
WG(debug)#config_http enable logon_html
alternate
Displays the current settings
This allows you to set the connection idle timeout
between the Vclass appliance and the Management
Station. The maximum time is 86,400 seconds (one
day). The default is 180 seconds (3 minutes).
WG#debug conn_idle_timeout 600
WG#debug conn_idle_timeout set_default
Displays the current settings
Enable instant state sync
Disable instant state sync
WatchGuard Vclass 5.1