Pppoe_Config Command; Radius_Ping Command - Watchguard V10 Command Line Interface Manual

pppoe_config command

pppoe_config [show | set <-i|-f|-r|-t> num | set_default]
show
set <-i|-f|-r|-t> num
set_default
Effect
Arguments
Example

radius_ping command

WG#debug<ENTER>
WG(debug)#radius_ping \
[-pap <"password">|-sid <"passcode">] \
[-p <port>] [-r <retries>] \
[-s <secret>] [-t <timeout>] \
[-u <username>] <source> <a.b.c.d>
Effect
WatchGuard Command Line Interface Guide
Debugging/troubleshooting commands
Show current settings.
Set PPPoE parameters.
-i is for echo interval (1-1200 Sec).
-f is for echo failure (1-60).
-r is for re-auth period (0-7200 Min).
-t is for re-auth interval (0-120 Min).
num is an integer.
Restore factory default value.
This command allows you to set PPPoE echo (keep-
alive) and re-authorization times and limits.
-i allows you to set the echo (keep-alive) interval,
from 1—1200 seconds.
-f allows you to set the threshold for echo (keep-
alive) failure, from 1—60 seconds.
-r allows you to set the re-authorization period,
from 0—7200 minutes.
-t alows you to set the re-autorization interval,
from 0—120minutes.
set_default allows you to set the default values
for PPPoE echo and re-authorization.
WG(debug)#pppoe_config set -1 300 -f 5\
-r 1800 -t 60
Use this command to test the connections between
this WatchGuard appliance and a RADIUS server.
135