Table of Contents
Advertisement
2.2.2021
Restore Factory Default Settings
If you ever need to, you can restore your Firebox to its factory-default settings. For example, if you do not
know the administrator account passphrase or you want to start over with a new configuration, you can
reset your device. Make sure you back up your device configuration before you reset your device in case
you want to restore it in the future.
To reset your device:
1. Power off the device.
2. Press and hold the Reset button, while you briefly press the Power button on the front of the
device to power it on.
3. Continue to hold the Reset button while the Arm indicator is red.
4. Continue to hold the Reset button while the Arm indicator slowly flashes green.
5. When the Arm indicator flashes green more rapidly, release the Reset button.
6. Wait until the Arm indicator starts to flash red.
7. Press and hold the Power button on the front of the device for five seconds to power off the
device.
8. Briefly press the Power button on the front of the device to power it on.
Hardware Installation
Your Firebox ships with a rack mount kit. It also supports user-installable components. This document
includes instructions to install your Firebox and its components:
Rack mount installation
Interface module installation
Power supply installation and replacement
Rack Mount Installation
Each Firebox device ships with rack mount ears for installation in a network rack.
Rack rail kit
2 sliding rails
https://www.watchguard.com/help/docs/help-center/en-US/Content/en-US/Hardware-Guides/firebox-m4800-hardware-guide.html
Firebox M4800 Hardware Guide
6/18
Advertisement
Table of Contents
