To Create And Apply Security Policies - Watchguard V10 Command Line Interface Manual

Command
WG(config)#cert
WG(config)#denial_of_service
WG(config)#high_availability
WG(config)#log

To create and apply security policies

To create and apply security policies, use these commands:
Command
WG(config)#address
WG(config)#service
WG(config-ike)#action
WG(config-ike)#policy
WG(config-ipsec)#action
WG(config-ipsec)#proposal
WG(config)#nat
WG(config)#vlan
WG(config-qos)#action
WG(config)#schedule
WatchGuard Command Line Interface Guide
Installing and configuring a WatchGuard appliance
Description
request and import needed certificates
from CA's
customize anti-hacker protection for
this appliance
set up and activate a high-availability
system, using the High Availibility
feature
includes event, traffic and alarm log
files
Description
create all the needed address groups for
use in policies
add new services or groups of related
services
create IKE actions for use in IKE
policies)
create IKE policies for use in IPSec
policies
create IPSec actions for use in IPSec
proposals
create IPSec proposals for use in
security policies
create NAT actions (DNAT, SNAT or
VIP) for use in policies
create VLAN IDs for use in policies
create QoS actions for use in policies
create schedules for application to
specific policies
21