Using The Emergency Stop Switch - Brother BAS-364E Instruction Manual

4. Using the emergency stop switch

Press the emergency stop switch 1 to immediately stop the sewing machine during actual sewing or when in the test
mode.
q
w
Note
There will be no response when the start switch or
work clamp lift switch is depressed or pressed when
the emergency stop switch q is pushed (the alarm is
sounding).
Reset
1. If the EMERGENCY STOP switch q is "turn lock type",
turn the EMERGENCY STOP switch q clockwise and
then pull it forward to release it.
2. Press the reset switch w . (The alarm will stop
sounding.)
3. If you do not wish to resume sewing, press the
EMERGENCY STOP switch q once more and then
press the reset switch w so that the program No. on
the operation panel flashes. The sewing machine will
then be ready for the next sewing operation.
If a problem occurs
If an abnormal load is applied or a problem occurs , the
emergency stop function is automatically activated, all
operations stop, and the alarm sounds. If the alarm is
sounding intermittently, correct the problem and press the
reset switch w to cancel the emergency stop mode.
If emergency stop function is not canceled even when
EMERGENCY STOP switch is pressed
Turn the power off, eliminate the cause of the problem,
and then turn the power back on.
BAS-364E, 366E, 370E, 375E
Chapter 5 OPERATING PROCEDURE
24