Using Single Split Mode - Brother BAS-364E Instruction Manual

9. Using single split mode

By using single split mode, it is possible to change up to 100 patterns immediately.
1. Move DIP switch B No. 1 to the ON position. This will activate single split mode.
(Refer to "Chapter 10 DIP SWITCH".)
2. Turn on the power read in the patterns which have been programmed for split sewing.
3. Press the MENU switch y until the SPLIT NO. indicator !1 is illuminated. "1" will then appear in the display screen
t. Then, while pressing the STEP BACK switch !7 , turn the dial !2 to change the contents appearing on the display
screen t in order.
Note
If three patterns have been programmed for split sewing, the number on the display screen changes in the
following order: "1" / "2" / "3" / "1" / "2"...
q
4. When the start switch is pressed, only the pattern displayed on the display screen t will be sewn.
Note
As to split sewing, refer to the instruction manual of the programmer.
A
B
e
w
BAS-364E, 366E, 370E, 375E
Chapter 5 OPERATING PROCEDURE
t
y !2 !7
28