Notes On Safety - Brother BAS-364E Instruction Manual

Notes on safety

x
Wait at least 5 minutes after turning off the power switch and disconnecting the power cord from the wall outlet before
opening the face plate of the control box Leg cover. Touching areas where high voltages are present can result in
severe injury.
Use the sewing machine in an area which is free from
sources of strong electrical noise such as high-
frequency welders.
Sources of strong electrical noise may cause problems
with correct operation.
Any fluctuations in the power supply voltage should
be within ±10% of the rated voltage for the machine.
Voltage fluctuations which are greater than this may
cause problems with correct operation.
The power supply capacity should be greater than the
requirements for the sewing machine's electrical
consumption.
Insufficient power supply capacity may cause problems
with correct operation.
The air supply should have a capacity greater than the
machine air consumption. If air is not supplied
sufficiently, a machine malfunction may occur.
Machine installation should only be carried out by a
qualified technician.
Contact your Brother dealer or a qualified electrician
for any electrical work that may need to be done.
The sewing machine weighs more than BAS-364E,
366E are 400 kg, BAS-370E, 375E are 600 kg. The
installation should be carried out by two or more people.
Do not connect the power cord until installation is
complete, otherwise the machine may operate if the
foot switch is pressed by mistake, which could result
in injury.
Be sure to connect the ground. If the ground connec-
tion is not secure, you run a high risk of receiving a
serious electric shock, and problems with correct
operation may also occur.
ii
DANGER
CAUTION
Environmental requirements
Installation
BAS-364E, 366E, 370E, 375E
The ambient temperature should be within the range
of 5°C to 35°C during use.
Temperatures which are lower or higher than this may
cause problems with correct operation.
The relative humidity should be within the range of 45% to
85% during use, and no dew formation should occur in any
devices.
Excessively dry or humid environments and dew formation
may cause problems with correct operation.
Avoid exposure to direct sunlight during use.
Exposure to direct sunlight may cause problems with
correct operation.
In the event of an electrical storm, turn off the power
and disconnect the power cord from the wall outlet.
Lightning may cause problems with correct operation.
All cords tube should be secured at least 25 mm away
from any moving parts. Furthermore, do not exces-
sively bend the cords or secure them too firmly with
staples.
Use the arm motor cover with the leg cover
installed.
If using a work table which has casters, the casters
should be secured in such a way so that they cannot
move.
Be sure to wear protective goggles and gloves when
handling the lubricating oil and grease, so that they do
not get into your eyes or onto your skin, otherwise in-
flammation can result.
Furthermore, do not drink the oil or eat the grease un-
der any circumstances, as they can cause vomiting
and diarrhoea.
Keep the oil out of the reach of children.