Operating The Emergency Stop Switch; Operating The Thread Wiper Switch (Ke-435C) - Brother KE-434C Instruction Manual

5-4. Operating the emergency stop switch

If the emergency stop switch is pressed while normal sewing or test sewing is being carried out, the sewing machine will
immediately stop operating.
2604Q

5-5. Operating the thread wiper switch (KE-435C)

Canceling an emergency stop
1. Turn the emergency stop switch (1) clockwise and then
pull it out to release the lock.
2. Press the RESET switch (2) on the control panel.
* The electronic alarm will stop sounding.
3. If not joining a new thread, press the RESET switch (2)
once more so that the display panel flashes. Turn the
pulley by hand to set the needle to the needle up stop
position, and then continue with sewing.
2605Q
Continuing sewing from a stopping point
2606Q
If the emergency stop switch was pressed because a thread
breakage occurred or the lower thread ran out, sewing can
be resumed from the point where the thread ended.
1. Turn the emergency stop switch (1) clockwise and then
pull it out to release the lock.
2. Press the RESET switch (2) on the control panel.
* The electronic alarm will stop sounding.
3. Press the BOBBIN. WIND switch (3) to trim the thread.
4. Press the BOBBIN. WIND switch (3) once more.
* The work clamp will move backward one stitch at a
time while this switch is being pressed. If the work
clamp moves back too far, press the TEST switch (4) to
move the work clamp forward. Press the TEST switch
2607Q
(4) once more when you would like the work clamp to
stop.
5. Once the work clamp has returned to the desired
position, depress the foot switch. The sewing machine
will then resume sewing.
0093Q
The thread wiper can be turned on and off using the thread
wiper switch (1).
2608Q
KE-434C,435C
5. OPERATION
25