Chapter 10 DIP SWITCH
Chapter 10 DIP SWITCH
Note
When changing DIP switch, the power must be off.
1. Panel DIP switch functions
I DIP switch A (on side of operation panel, at the top)
SW No.
Presser foot rises when presser lift switch is pressed, and does not rise automatically after
A-1
sewing is complete.
A-2
Selecting work clamp operation
A-3
-
A-4
-
A-5
For split timing only, presser foot is not raised automatically after sewing is complete.
A-6
-
Single pedal specifications using mobile foot switch. Work clamp drops when foot switch is
A-7
depressed, and sewing starts when foot switch is released.
A-8
Thread trimming sensor operation is enabled.
I DIP switch B (on side of operation panel, at the bottom)
SW No.
B-1
Independent split mode is activated.
B-2
Split data is ignored (continuous split mode).
B-3
Thread is not trimmed after an emergency stop.
B-4
Needle cooler operates.
B-5
Thread breakage sensor sensitivity is reduced.
B-6
-
B-7
-
B-8
Feeding speed is increased.
49
When ON
When ON
BAS-364E, 366E, 370E, 375E