Using The Program R/W (Read/Write) Switch - Brother BAS-364E Instruction Manual

Chapter 5 OPERATING PROCEDURE

3. Using the program R/W (Read/Write) switch

Programmed stitch patterns stored on floppy disk can be read into memory, and newly programmed pat terns can be
written to disk for permanent storage and later recall.
q
w
e
r
y
23
t
BAS-364E, 366E, 370E, 375E
Insert the floppy disk q containing or which is to contain
the programmed stitch pattern.
To READ a pattern to memory
Press the program select switch e on the operation panel.
The program number will then appear in the PROGRAM
NO. display w. After selecting the desired program num-
ber, press the R/W switch r. The disk drive indicator t
will illuminate and a "P" will appear on the PROGRAM
NO. display w to indicate that the data is being read. When
the alarm sounds and the disk drive indicator t turns off,
the program number will then flash in the PROGRAM NO.
display w instead of the "P" to indicate that the reading of
the data is complete.
To WRITE a pattern to disk
Press the program select switch e on the operation panel
to select the desired program number. After programming
the pattern using the stitch programmer, press the R/W
switch r. The disk drive indicator t will illuminate and a
"P." will appear on the PROGRAM NO. display w to indi-
cate that the data is being written. When the alarm sounds
and the disk drive indicator t turns off, the program num-
ber will then flash in the PROGRAM NO. display w in-
stead of the "P" to indicate that the writing of the data is
complete.
If an error code is displayed
If an error code is displayed in the display w, and alarm
will sound.
Press the reset switch y on the front of the machine to
stop sewing machine operation, and then refer to and fol-
low "Chapter 12 ERROR CODE".