Using The Test Switch (Checking The Sewing Pattern) - Brother BAS-364E Instruction Manual

7. Using the TEST switch (Checking the sewing pattern)

Do not touch any of the moving parts or press any objects against the machine while sewing, as this may
result in personal injury or damage to the machine.
Use the TEST switch to move the presser foot without sewing to check the sewing pattern.
Use the TEST switch to begin sewing again from any desired point when the thread breaks or the bobbin
thread runs out.
!6
!5
CAUTION
!7
q
w
BAS-364E, 366E, 370E, 375E
Chapter 5 OPERATING PROCEDURE
1. Press the TEST switch !5 . The test indicator !6 will
light.
2. If the work clamp is raised, depress the work clamp lift
switch w to lower the work clamp.
3. Press the start switch q.
Note
After the feed mechanism has returned to the home
position, it will then move the sewing start position
and the program number will stop flashing.
This only occurs the first time that a program is
selected.
4. Press the start switch q. (The needle will remain
stationary as the work clamp advances through the
pattern at low speed one stitch at a time. Press the
work clamp lift switch w to fast forward.
If the STEP BACK switch !7 is pressed while moving
at low speed, the work clamp will move in the forward
direction in steps of 100 stitches.
5. When the work clamp reaches the desired position,
press the TEST switch !5 . The work clamp will stop,
and the test indicator !6 will go out. If the work clamp
was stopped too early, press the TEST switch !5 again
to proceed.
If the work clamp was stopped too late, press the STEP
BACK switch !7 to advance the work clamp one stitch
at a time.
Resuming operation from a stopping point
6. Sewing will start when the start switch q is pressed.
26