Operating The Emergency Stop Switch; Operating The Thread Wiper Switch - Brother KE-484C Instruction Manual

5. OPERATION

5-4. Operating the emergency stop switch

If the emergency stop switch is pressed while normal sewing or test sewing is being carried out, the sewing machine will
immediately stop operating.
3167Q

5-5. Operating the thread wiper switch

23
Canceling an emergency stop
1. Turn the emergency stop switch (1) clockwise and then
pull it out to release the lock.
2. Press the RESET switch (2) on the control panel.
* The electronic alarm will stop sounding.
3. If not joining a new thread, press the BOBBIN. WIND
switch (3) to trim the thread. Then, press the RESET
switch (2) once more so that the display panel flashes.
Turn the pulley by hand to set the needle to the needle up
stop position, and then continue with sewing.
2605Q
Continuing sewing from a stopping point
2606Q
If the emergency stop switch was pressed because a thread
breakage occurred or the lower thread ran out, sewing can
be resumed from the point where the thread ended.
1. Turn the emergency stop switch (1) clockwise and then
pull it out to release the lock.
2. Press the RESET switch (2) on the control panel.
* The electronic alarm will stop sounding.
3. Press the BOBBIN. WIND switch (3) to trim the thread.
4. Press the BOBBIN. WIND switch (3) once more.
* The work clamp will move backward one stitch at a
time while this switch is being pressed. If the work
clamp moves back too far, press the TEST switch (4) to
move the work clamp forward. Press the TEST switch
2607Q
(4) once more when you would like the work clamp to
stop.
5. Once the work clamp has returned to the desired
position, depress the start switch. The sewing machine
will then resume sewing.
3168Q
The thread wiper can be turned on and off using the thread
wiper switch (1).
Note:
When memory switch 2F (memo-2F) is ON, turn off the
power switch before operating the thread wiper switch.
If you operate the thread wiper switch while the power is still
turned on, the work clamp may obstruct the thread wiper.
3169Q
KE-484C