Chapter 4 Correct Operation; Turning The Pulley By Hand; Installing The Needle - Brother BAS-364E Instruction Manual

Chapter 4 CORRECT OPERATION

1. Turning the pulley by hand

If the power switch and air need to be left on when carrying out some adjustment, be extremely careful to
observe all safety precautions.
w
r
e
q

2. Installing the needle

Turn off the power switch at the following times, otherwise the machine may operate if the start switch is
pressed by mistake, which could result in injury.
When replacing the needle
G
CAUTION
After pressing the hand pulley q in, it can then be turned
by hand. To return the hand pulley q, pull the lever w
toward you.
* Furthermore, the hand pulley q will automatically return
to its original position at the sewing start and when the
work clamp is raised and lowered.
Note
Do not touch the hand pulley q, lever w, work clamp
lifter arm e or cylinder r while the machine is
operating and when the work clamp is being raised
and lowered, otherwise injury may result.
CAUTION
Loosen set screw q. Fully insert the needle w with the
groove facing the front, and then retighten set screw q.
Note
Always make sure that the needle w is fully inserted
G
facing the front.
If the needle is installed incorrectly, problems such
G
as needle breakage may occur.
q
w
BAS-364E, 366E, 370E, 375E
Chapter 4 CORRECT OPERATION
12