Changing The Presser Foot Lift Amount - Brother BAS-364E Instruction Manual

Chapter 7 STANDARD ADJUSTMENTS

5. Changing the presser foot lift amount

Standard presser foot q lift is 3.2 mm. (Max. 7.2 mm)
!2
!0
u
Adjusting the stepping foot stroke
1. Remove the face plate w.
2. Loosen the nut e. After adjusting the position of the stepping foot connecting rod r, tighten the nut e again.
3. Turn the hand pulley to set the stepping foot q to its lowest position.
4. Loosen the screw y of intermittent feed arm (L) t, and then adjust the position of intermittent feed arm (L) t so
that the screw i of the presser bar clamp u is positioned at the center of the slot on the intermittent support
assembly o. Then tighten the screw y.
If it is not necessary to move the presser foot up and down
1. Remove the stud screw !0 , and reattach link (L) !1 to the other screw hole of the intermittent feed shaft !2 .
2. Turn on the power. Make sure that the red lamp on the sensor !3 is lit. If the lamp is not lit, adjust the position of the
sensor !3 .
Note
If the lamp is not lit, the sewing speed will not exceed 2000 rpm.
37
q
r
!1
o
i
BAS-364E, 366E, 370E, 375E
e
3.2 mm (max.7.2 mm)
!3
y
t
Increase
Decrease
w