If The Machine Stops During Sewing; If The Emergency Stop Switch Is Pressed (E-100); Resetting The Belt Loops; Removing An Overlapping Loop While In The Sewing Standby Condition - Brother BAS-705 Instruction Manual

4-7-2. If the machine stops during sewing

Press the EMERGENCY STOP switch. The error code (E-100) will appear on the screen and the ma
chine will stop at the step where the switch was pressed.

4-7-3. If the EMERGENCY STOP switch is pressed (E-100)

During AUTO mode
Before the machine head starts
1. Unlock the EMERGENCY STOP switch.
2. Press the RESET switch. The error will be cleared and the machine will switch to sewing standby
mode.
During HEAD mode
Before the machine head starts
1. Unlock the EMERGENCY STOP switch.
2. Press the RESET switch. The error will be cleared and the machine will switch to sewing standby
mode.

4-7-4. Resetting the belt loops

If the LOOP switch is pressed when DIP switch No. 2-7 is set to OFF, the machine will be reset. If the
LOOP switch is pressed once more, a new belt loop will be set.
* If the LOOP switch is pressed when DIP switch No. 2-7 is set to ON, the machine will be reset, and then
a new belt loop will be set straight away.

4-7-5. Removing an overlapping loop while in the sewing standby condition.

Press the CANNCEL switch.Presser block B will be raised and it will then be possible to remove the
loop.

4-7-6. Stopping sewing when the presser foot is lowered

1. If DIP switch No. 1-8 on the panel is set to ON, the presser foot will be lowered and stay in this
conditionwhenautomatic sewing is completed.
2. If the RESET switch is pressed, the presser foot will be raised.

4-7-7. Raising and lowering the presser foot

1. If the FOOT switch is pressed while the machine is in sewing standby mode, the presser foot will be
lowered.
2. If the RESET switch is pressed, the presser foot will be raised.
Refer to "4-6-1. Raising and lowering the presser foot" on page 29.

4-7-8. If the upper thread breakage codes (E-181, E-182) are displayed

Press the RESET switch. The machine will switch to sewing standby mode.
Refer to "4-6-2 If the upper thread breakage codes (E-181, E-182) are displayed" on page 30.

4-7-9. If an error code is displayed during sewing

Refer to "Error Codes" on page 70.
33
4. SEWING
BAS-705