Chapter 12 Error Code - Brother BAS-364E Instruction Manual

Chapter 12 ERROR CODE

Chapter 12 ERROR CODE
Wait at least 5 minutes after turning off the power switch and disconnecting the power cord from the wall
outlet before opening the face of the control box. Touching areas where high voltages are present can result
in severe injury.
Note
If an operation problem occurs, buzzer will sound and an error code will appear on the display screen;
G
if a programmer is connected, an error message will appear on the screen.
Wait 10 seconds or more after turning the power off before turning it back on again.
G
code
E. 10 Emergency stop switch was pressed.
Emergency stop switch was pressed during
E. 11
sewing.
Emergency stop switch is activated or its
E. 12
connection is not correct.
E. 20 Z motor or Z servo amp trouble.
E. 22 Needle up stop position error.
Data exceeds available sewing area due to resize
E. 30
ratio.
Stitch length exceeds 12.7mm due to resize
E. 31
ratio.
E. 32 No end code in sewing data.
Floppy disk is not inserted or operation panel cable
E. 40
is not securely connected.
E. 41
Invalid program No.,or no data.
E. 43
Different floppy disk!
E. 4F Error occurred during floppy disk data reading.
E. 50 Floppy disk is write-protected.
E. 51 Insufficient available memory on floppy disk.
E. 52 Can not format this floppy disk.
E. 5F Error occurred during data writing on floppy disk.
E. 81 Upper thread has broken.
Start switch was pressed when there was no
E. A0
sewing available data.
E. A1 Can not detect home position.
E. A2 Jig pattern sensor error.
57
DANGER
Cause
BAS-364E, 366E, 370E, 375E
Remedy
Press the emergency stop switch once more to cancel.
Press the emergency stop switch once more to cancel.
The STEP BACK switch can then be used to resume sewing.
Turn off the power and check.
Turn off the power, and then turn the machine pulley to
check if the machine has locked up. Check the
synchronizer connection. Check if connectors P14, P15
or P16 are disconnected.
Turn the pulley to align the index mark with the needle
up stop position. Check the V-belt tension.
Check the enlargement or reduction ratio setting.
Check the enlargement or reduction ratio setting.
Input an end code, or change the program number.
Insert a floppy disk. If floppy disk is already inserted,
turn off the power and check the connection of cords
inside the operation panel.
Check the floppy disk.
Replace with a readable floppy.
Replace the floppy disk and repeat the operation.
Remove the write-protection.
Use a different floppy disk.
Replace the floppy disk and repeat the operation.
Repeat the operation.
Thread the upper thread. Re-sewing is possible.
Re-read the sewing data.
Turn off the power and check the X-Y feed and the home
position sensor connection.
Re-read the sewing data.