Disabling The Isns Client Service - HP A7533A - Brocade 4Gb SAN Switch Base Administrator's Manual

3. Enter the fosConfig - -show command to verify that the service is enabled:
4. switch:admin> fosconfig --show
5. FC Routing service:disabled
iSCSI service:enabled
iSNS Client service:enabled
6. Set the IP address of the iSNS server. You can use either the IP address of the GbE port that attaches
the FC4- 1 6IP blade, or the server management port IP address.
Enter the isnscCfg - -set command with the -m and -s options to set GbE port IP address:
switch:admin> isnsccfg --set <slot>/ge<port> -s <IP_address>
where
• <slot> is the number of the slot where the FC4- 1 6IP blade is inserted.
• ge<port> is the physical GbE port number (ge followed by 0–7, for example, ge0).
• <IP_address> is the iSNS server IP address.
The following is an example.
switch:admin> isnsccfg --set 10/ge0 -s 10.32.0.145
iSNS client configuration updated:
peering with iSNS server 10.32.0.145 on slot 10, port ge0.
Enter the isnscCfg - -show command to verify that the iSNS server has been configured correctly:
switch:admin> isnsccfg --show
iSNS client is peering with iSNS server 10.32.0.145 on slot 10, port ge0.
Operational Status: Connected to iSNS server.
Enter the isnsccfg - -set command with the -m and -s options to set the IP address of the iSNS
server management port rather than the GbE port:
switch:admin> isnsccfg --set -m -s <IP_address>
where <IP_address> is the iSNS server management port IP address.
The following is an example.
switch:admin> isnsccfg –set –m –s 10.33.56.105
iSNS client configuration updated: peering with iSNS server 10.33.56.105 on the
management port.
7. Enter the isnscCfg - -show command to verify that the iSNS server has been configured correctly:
switch:admin> isnsccfg --show
iSNS client is peering with iSNS server 10.33.56.105 on the management port.
Operational Status: Connected to iSNS server.
8. Enter the isnsccfg - -reregister command to re-register the iSNS objects:
switch:admin> isnsccfg --reregister

Disabling the iSNS client service

When the iSNS client service is disabled, the DD and DDSets are kept in the fabric.
1. Connect and log in to the switch.
2. Enter the fosConfig - -disable isnsc command to disable the iSNS client service:
switch:admin> fosconfig --disable isnsc
3. Enter the fosConfig - -show command to verify that the service is disabled:
switch:admin> fosconfig --show
FC Routing service:disabled
iSCSI service:enabled
iSNS Client service:disabled
Fabric OS 6.1.x administrator guide 277