HP A7533A - Brocade 4Gb SAN Switch Base Administrator's Manual page 49

To view the switch status policy threshold values:
Connect to the switch and log in using an account assigned to the admin role.
1.
2. Enter the switchStatusPolicyShow command.
Whenever there is a switch change, an error message is logged and an SNMP
connUnitStatusChange trap is sent.
The output is similar to the following:
switch:admin> switchstatuspolicyshow
The current overall switch status policy parameters:
----------------------------------
PowerSupplies
Temperatures
Fans
WWN
CP
Blade
Flash
MarginalPorts
FaultyPorts
MissingSFPs
The policy parameter determines the number of failed or inoperable units for each contributor that will
trigger a status change in the switch.
Each parameter can be adjusted so that a specific threshold must be reached before that parameter
changes the overall status of a switch to MARGINAL or DOWN. For example, if the FaultyPorts DOWN
parameter is set to 3, the status of the switch will change if 3 ports fail. Only one policy parameter needs
to pass the MARGINAL or DOWN threshold to change the overall status of the switch.
For more information about setting policy parameters, see the Fabric Watch Administrator's Guide.
To set the switch status policy threshold values:
1. Connect to the switch and log in using an account assigned to the admin role.
2. Enter the switchStatusPolicySet command.
The current switch status policy parameter values are displayed. You are prompted to enter values for
each DOWN and MARGINAL threshold parameter.
By setting the DOWN and MARGINAL values for a parameter to 0,0 that parameter is no longer used
in setting the overall status for the switch.
Down Marginal
3 0
2 1
2 1
0 1
0 1
0 1
0 1
2 1
2 1
0 0
Fabric OS 6.1.x administrator guide 49