HP A7533A - Brocade 4Gb SAN Switch Base Administrator's Manual page 398

The following example shows an active tunnel with FCIP fastwrite and tape pipelining enabled:
switch:admin06> portshow fciptunnel ge0 all
-------------------------------------------
Tunnel ID 0
Remote IP Addr 10.0.10.224
Local IP Addr 10.0.10.225
Remote WWN Not Configured
Local WWN 10:00:00:05:1e:37:91:dd
Compression on
Fastwrite on
Tape Pipelining on
Uncommitted bandwidth, minimum of 1000 Kbps (0.001000 Gbps)
SACK on
Min Retransmit Time 100
Keepalive Timeout 10
Max Retransmissions 8
DSCP Marking (Control): 10, DSCP marking (Data): 50
Status : Active
Uptime 21 seconds
If IPSec has been enabled and a policy added to the configuration, you will see the policy information
under the status section of the output, as shown below. The policy information is visible only when IPSec is
configured and is displayed with the information shown in the example above when the portShow
command is issued.
IKE Policy 1
Authentication Algorithm: SHA-1
Encryption: 3DES
Perfect Forward Security: off
Diffie-Hellman Group: 1
SA Life (seconds): 3600
SA Life (MB): 4500
IPSec Policy 1
Authentication Algorithm: SHA-1
Encryption: 3DES
Perfect Forward Security: off
Diffie-Hellman Group: 1
SA Life (seconds): 3600
SA Life (MB): 4500
Pre-Shared Key 0x1234500000000000000000000000000000
After FCIP tunnels are created, the configuration is saved in a persistent database. At this point, all
configured FCIP tunnels now appear in the fabric as VE_Ports.
398 Configuring and monitoring FCIP extension services